>
Go to: Homepage SpaceGuard SRM. Disk Quota Management Software.

Service Configuration - Setup Cluster Mode

SpaceGuard SRM software can also be used on cluster configurations. No special additions are needed.

All Microsoft Cluster (MSCS) configurations (active-active, active-passive) are supported. It will take a few minutes to install the SpaceGuard SRM service on a cluster configuration (see below).

Steps to install SpaceGuard SRM on a cluster:

Notes: Do not define a generic service in your cluster when installing SpaceGuard SRM

1. Install the SpaceGuard SRM service on all nodes in the cluster (see Installing a SpaceGuard SRM service). Please make sure that the "Enable cluster software" checkbox in the advanced section is checked. (Note: This option can also be enabled after service installation (see Service Configuration - Cluster).

2. Make sure that both servers have the same "Configuration Path" specified (see Service Configuration - Cluster). This path is a relative path, since the Microsoft Cluster software assigns a disk automatically, and will be created on each shared cluster disk. For example: \SpaceGuard SRM Service\

See also:

Installing a SpaceGuard SRM service

Service Configuration